Loss of Well Control
Effective Date: 12/19/2002
 | U.S. Department of the Interior |
| Safety Alert No. 208 December 19, 2002 | Contact: Cliff Delouche |
Loss of Well Control
Recently, a kick was observed during the wash-over of a gravel pack. Observed pressures were 1,100 psig on the casing and 1,800 psig on the workstring. Well-control operations were initiated by bull-heading into the well, at which time pressure rose to 4,200 psig. The PSV located on the mud pump relieved, allowing a mixture of gas, sand, and completion fluid to escape and inundate the area around the drill floor and rig equipment. On at least two occasions prior to the incident, the PSV had been subjected to pressures at or near its set pressure of 5,000 psig during BOP tests.
It was concluded in an MMS investigation of the incident that the PSV shear pin failed below its set pressure because of a possible deformity of the pin resulting from repeated exposure to pressures at or near its set pressure during testing. It was further concluded by MMS that an apparent failure to inspect the shear pin visually after such pressure exposures would have revealed the aforementioned deformity and thus represents a possible contributing cause of the incident.
It is therefore recommended to operators and contractors that:
PSV shear pins should be visually inspected for integrity after having been exposed to pressures at or near their relief pressures.
PSV’s should be maintained in accordance with manufacturer’s recommendations.
PSV discharges should be piped to a safe location so as to minimize interference with operations.